Pre-start Preparations
① Check the area around the equipment for dust and debris, and remove them.
② Load the film rolls according to the production order requirements.
③ Adjust the bag dimensions according to the production order and process documents, install the heat-sealing knife, and initially adjust the positions of the slitting knife and heat-sealing knife.
⑤ Turn on the power and set the heat-sealing knife temperature according to the process documents.
⑥ Input the relevant bag-making data and the required number of bags per bundle.
⑦ Select the edge of the pattern with the largest color difference and adjust the sensitivity of the photosensitive eye to meet the requirements.
Start-up
① Start the main motor and run it at low speed. Then adjust the edge control to align the film in the middle position.
② Adjust the left and right clamping rollers to align the left and right films, and adjust the front and rear clamping rollers to align the pattern.
③ Adjust the heat-sealing knife to heat-seal within the required range of the bag.
④ Adjust the slitting blade to the required position and adjust the perforation position to the scissor edge. ⑤ After initially adjusting the machine speed, take a sample bag produced in one pass for initial inspection.
⑥ During production, continuously observe the bag-making process and adjust immediately if any abnormalities are found.
Shutting down the machine
Disconnect the main power switch, and then disconnect the power switches of each component.
